STEP 1
Press the two 1/2’’ pvc pipes together. Press bungee end plug onto 1/2’’ pvc. Insert the bungee cord through 1/2’’ pvc end and bungee end plug. Slide the flat washer on bungeeat the pvc end and tie a knot.
STEP 2
Tie the knot near the bungee end plug. Slide the vinyl piece provided onto bungee cord, Slide eyebolt onto bun-gee, slide flat washer on bungee cord and tie a knot.
STEP 3
Insert assembled bungee kit into 2’’ roll tube and tap bun- gee endplug into the end of the roll tube. A small set screw can be drilled into endplug to hold into place.
STEP 4
Determine Bungee Tension
INSTALLATION TIP: A good guide when deciding bungee length is to roll the tarp so it hangs down and the bungee should be approximately the same length. This should be done out of the wind.
STEP 5
After the tarp has been installed drill 5/16’’ hole through latchplate 1/2’’ from front end. Insert eyebolt through hole and secure with 5/16’’ nuts and lock washer.
INSTALLATION TIP: 1/2’’ Self tapping screw is provided to secure bungee plug in pipe.